SeaDoo RX Instrukcje Operacyjne Strona 30
- Strona / 91
- Spis treści
- ROZWIĄZYWANIE PROBLEMÓW
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
28
Chronometer
While in the chronometer mode:
1. Press to start or stop chronometer
1. Press and hold for 2 seconds to reset
Maintenance Information
When the watercraft is due for a mainte-
nance inspection, the message MAINT
will blink.
To clear the warning message while it
is blinking:
1. Press and hold for 2 seconds to reset
NOTE: If maintenance message
(MAINT) continues to blink, it indicates
a fault with the fuel injection system on
Di models. Refer to an authorized Sea-
Doo Dealer for servicing.
10) Glove Box
A small, convenient storage compart-
ment for personal articles.
11) Fuel Tank Valve
Carburetor-Equipped Models
A 3-position rotating valve: OFF, ON
and RESERVE:
OFF: Stop fuel supply to carburetor(s).
CAUTION: Turn valve to OFF posi-
tion when watercraft is not operated.
ON: Allows fuel to flow to carbure-
tor(s). This is the normal position
for operation of watercraft.
CAUTION: Improper opening of fuel
valve may restrict flow of fuel and
may lead to engine damage. Make
sure valve is fully opened while run-
ning.
RES: Use when the watercraft has run
out of fuel in the ON position.
Always refill the fuel tank at the first
opportunity. After refueling, turn the
fuel tank valve to the ON position to
continue operation.
12) Fuel Tank Cap
Open the front storage compartment
cover to expose fuel tank cap.
The tank cap is located on the left hand
side of the watercraft.
Unscrew the cap counterclockwise. Af-
ter fueling, reinstall cap and fully tighten.
13) Oil Injection Reservoir
Cap
Open the front storage compartment
cover to expose reservoir cap.
The reservoir cap is located on the right
hand side of the watercraft.
To add injection oil in the reservoir, un-
screw the cap counterclockwise. Do not
overfill. Reinstall cap and fully tighten it.
F00L2B0
1
F00L2B0
1
F00L2B0
1
WARNING
Never use a lit match or open flame
to check fuel level.
smo2000-003a.book Page 28 Thursday, November 11, 1999 10:44 AM
www.SeaDooManuals.net
- Videocassette 3
- Operator’s Guide 3
- Safety Handbook 3
- Piloting 3
- TABLE OF CONTENTS 4
- FOREWORD 7
- SAFETY WARNING 8
- Maintenance 11
- LIST OF DISTRIBUTORS 12
- AMERICA: 2000 SEA-DOO 13
- WATERCRAFT 13
- WARRANTY: 2000 SEA-DOO 15
- REGISTRATION NUMBER LOCATION 17
- Label 1 Label 2 18
- DO NOT BOOST BATTERY 19
- WHILE INSTALLED 19
- IDENTIFICATION NUMBERS 20
- RX/DI Models 21
- GTX DI Models 22
- COMPONENTS FUNCTIONS 24
- 2) Handlebar 25
- 3) Throttle Lever 25
- 4) Engine Start/Stop 25
- All Models 26
- Carburetor-Equipped Models 26
- RX Models 26
- 1. Position indicator 28
- 2. Bow up 28
- 3. Bow down 28
- 10) Glove Box 30
- 11) Fuel Tank Valve 30
- 12) Fuel Tank Cap 30
- 13) Oil Injection Reservoir 30
- Step : Lift 31
- 1. Holder 31
- 19) Seat Latch 32
- 30) Flushing Connector 35
- 31) Bilge Drain Plugs 35
- 32) Jet Pump Nozzle 35
- 33) Reverse Gate 35
- 34) Jet Pump Water Intake 35
- FUEL AND LUBRICATION 36
- Oil Injection System 37
- BREAK-IN PERIOD 38
- DAILY PRE-OPERATION CHECKS 39
- 1. Inspect this area 40
- OPERATING INSTRUCTIONS 42
- 3. Nozzle up 44
- Boarding the Watercraft 45
- A. 90 cm (3 ft) 46
- Starting the Engine 47
- Rough Water or Poor 48
- Visibility Operation 48
- Crossing Waves 48
- Stopping/Docking 49
- Beaching 49
- Shutting Off the Engine 49
- POST-OPERATION CARE 50
- DI Models 51
- Anticorrosion Treatment 52
- SPECIAL PROCEDURES 53
- Capsized Watercraft 54
- Submerged Watercraft 54
- Water-Flooded Engine 54
- Fuel-Flooded Engine 55
- Out of Fuel 56
- Towing the Watercraft in 56
- Low-charge Battery 56
- Condition 56
- MAINTENANCE 57
- Periodic Inspection 58
- Periodic Inspection Chart 59
- WARNING 61
- VTS Adjustment 62
- (if so equipped) 62
- Vacuum Bailer Pick-Ups 62
- General Inspection and 64
- Cleaning 64
- TRAILERING, STORAGE 65
- AND PRE-SEASON PREPARATION 65
- 1. Bleed outlet hose 69
- 1. Engine drain hose 69
- 1. Water regulator valve 69
- 2. Supply hose 69
- Pre-Season Preparation 70
- Pre-Season Preparation Chart 71
- TROUBLESHOOTING 72
- Engine Will Not Start 73
- Engine Overheats 74
- Engine Continually Backfires 74
- Engine Pinging or Knocking 74
- SPECIFICATIONS 76
- SI* METRIC INFORMATION 80
- DEALER IMPRINT AREA 82
- CHANGE OF ADDRESS 83
Powiązane produkty i podręczniki dla Silnik SeaDoo RX
Silnik SeaDoo GTI LE Instrukcja Użytkownika
(22 strony)
(22 strony)
Silnik SeaDoo GSI Instrukcje Operacyjne
(105 strony)
(105 strony)
Silnik SeaDoo GTX 4-TEC Instrukcje Operacyjne
(104 strony)
(104 strony)
Silnik SeaDoo GTI LE Dokumentacja
(130 strony)
(130 strony)
Silnik SeaDoo GS Instrukcje Operacyjne
(109 strony)
(109 strony)
Silnik SeaDoo GTI LE RFI Dokumentacja
(121 strony)
(121 strony)
Silnik SeaDoo GSX Limited Instrukcja Użytkownika
(11 strony)
(11 strony)
Silnik SeaDoo XP DI Instrukcje Operacyjne
(24 strony)
(24 strony)
Silnik SeaDoo SP Instrukcja Obsługi
(316 strony)
(316 strony)
Silnik SeaDoo GS Instrukcje Operacyjne
(100 strony)
(100 strony)
Silnik SeaDoo GSX Instrukcja Obsługi
(56 strony)
(56 strony)
Speco Technologies VL7038IRVF manuali
Manuali dei proprietari e guide per l'utente per Sistemi di video.sorveglianza Speco Technologies VL7038IRVF.
We fornisce 1 manuali pdf Speco Technologies VL7038IRVF per scaricare gratuitamente in base al tipo di documento: Manuale Utente
Komentarze do niniejszej Instrukcji